EQ, compressor and limiter
AudioEvery source, Master and every bus has an EQ, a compressor and a limiter of its own, built in. There is nothing to install: press the FX button on a strip in the audio mixer, or the one at the top of the meter beside Preview or Program, and they are the three rows at the top of the window, above any VST3 effects.
Each row has its own switch on the right, and a line saying what it is set to. Click its name to open it and adjust it. All three start off, and a strip or mix with one on has an orange FX button, as one with a plug-in has.
They run in this order, EQ, compressor, limiter, and before any plug-ins. Changes are heard as you make them, while audio keeps running.
EQ
Five bands, numbered on the curve:
- High-pass, which takes away what is below its frequency: rumble, wind, a stand being knocked.
- Bell or low shelf: a bell lifts or cuts around its frequency, a shelf everything below it.
- Bell.
- Bell or high shelf: a shelf lifts or cuts everything above its frequency.
- Low-pass, which takes away what is above its frequency.
The high-pass and low-pass have a slope, how steeply they take it away: 12, 24, 36 or 48 dB per octave. The others have a gain and a Q, how wide a bell is, or how steep a shelf is.
- Drag a point on the curve to move its band: across for its frequency, up and down for its gain. Dragging a band that is off switches it on.
- The scroll wheel over a bell or a shelf makes it wider or narrower.
- Double-click a point to put its band back where it started.
- Below the curve, each band has its own tick box, and its values to type. Reset EQ puts every band back, switched off.
While the EQ is open and audio is running, the sound coming out of it is drawn behind the curve, so you can see where a problem is before you cut it.
Compressor
The compressor brings loud moments down towards quiet ones, so a voice sits at an even level.
- Threshold: the level it starts to work above.
- Ratio: how strongly. At 4:1, sound 8 dB over the threshold comes out 2 dB over it.
- Attack and Release: how quickly it turns the sound down, and how quickly it lets it back up.
- Make-up gain: brings the whole sound back up afterwards.
The meter shows how far it is turning the sound down, growing from the right.
Limiter
The limiter makes sure nothing goes over its Ceiling: a safety net on Master before the stream and the recording, or on a microphone that someone may shout into.
- Input gain makes the sound louder before the limiter, so it can be loud and still never over the ceiling.
- Ceiling is the most it lets out. It counts the peaks between samples too (true peak), as streaming platforms measure them: −1 dBTP is a safe ceiling for the stream.
- Release: how quickly it lets the sound back up after a peak.
To catch every peak it looks 1.5 ms ahead, so the sound through it is 1.5 ms later. Every picture waits for that while it is on, as for any effect that delays the sound, so lip sync holds.
Saving them
A saved effect chain, from the Chains menu, keeps the EQ, compressor and limiter with its plug-ins, and loading it sets them. A chain can be the three on their own, with no plug-ins at all. A chain saved before they existed switches them off when it is loaded, and keeps their settings for when you switch them on again.
Next
Adding a VST3 effect, for anything more, and the audio mixer.